I was in a situation without internet access and had done the initial SBS install and the CTTI wizard had said it was happy ( in the process I had manually specified the ip and router, and waited through it's huge long searching delay). But I could not run the Internet Address wizard. I suspected there was a way to fool the system - this situation had to be allowed. Running through the process various ways, I usually wound up with CTTI wizard unhappy on the reachable internet outcome and for sure it would not allow the Internet Address wizard. Funny that it did when it reported ok originally.
So following these steps this all works, and it is pretty funny when you see the wizard change its tune from "You don't have an internet connection" to "I see you have an internet connection" hahaha.
Wish I could have commented on the original page, but this post will have to do. Thanks y'all!
Quick Summary in case that site or page goes away:
Get to the point int he wizard where you can enter the IP and Router manually.
When prompted for "Do you want to continue without discovery" answer YES
Then hit TEST
Then hit SKIP TEST
No comments:
Post a Comment